Search results

https://www.fordwagon1938.com/

The wavy washer goes where? Between the bolt head and the hinge? Or the hood and the hinge? Thanks

Seems easy enough to remove the hood stainless strip by closing the clips together. Anyone have experience with these? The big question is what if they metal fatigue, are there replacements available?? The F O R D letters on the hood, how are they removed? Gentle tapping from the inside...

Ref 49 wagon Attaching the OD cable with an Addell clamp, which is OK, there is some movement of the cable inside the clamp. Using the side of the transmission as a mounting point. Should I be using the smooth end of the cable? What is the preferred method of mounting and the type of...

Ref 49 bellhousing - see attached photos. The two rivets, one is loose the other's head is broken. What are your thoughts on welding the bracket in place vs. riveting or flat head cap screws with metallic locking nuts.

Changing out intake manifold, and found this part, somewhat fitting in the hole in the block. The hole is in the rear driver side, of the block. Any idea what this is, what it does and where it goes? Thanks

Installed these on a stock suspension - did not need them. $40.00 plus UPS Paypal preferred All hardware included. Ref: https://shoebox-central.com/4953camkit-1949-1950-1951-1952-1953-ford-mercury-camber-adjustment-kit Attached Files:

SOLD SOLD 49 Ford 12V Powermaster Starter For Sale NEW SOLD $130.00 plus UPS from 92886. Boxed in original packaging. Weighs about 10 lbs.

Has anyone used this: Will the stock 6V relay operate on 12V? Thinking, half current, and 2x volts, not so sure. Vintage Auto makes an improved version for 12V: https://vintageautogarage.com/borg-warner-r10-r11-overdrive-relay-12-volts/?gclid=Cj0KCQiA9YugBhCZARIsAACXxeLQfSrO0BVdF3PTqGE8

Ref: https://www.dennis-carpenter.com/trucks/electrical/starter/18-11002-n12v-new-starter-12-volt-replacemen The new improved modern starter? The new Bendix will not fit, as it will not get past the flywheel. The solution? Take it off and replace it with the original style Bendix. Had...

Searched the forum and online for the location of the drain plug for the BW overdrive. Fill plug is there. Just below the fill plug there is what appears to be a hex head pipe plug - is the drain plug? . Came across this article while searching around on the interweb...

The 2 door wagon shocks are different than the sedan. Anyone have recommendations that fit correctly and perform? Thanks

Ref 49 rear axles have a small groove from the leather seals. Installing the Speedi Sleeves - use the installation tool and use a pipe over the axle shaft to drive the sleeve into place. Any other ideas would be appreciated. thanks

Found them. Looking for (2) part number 8A-5630 spring bolts. Thanks, Warren - located in Orange County CA. menlotrail@gmail.com

What has worked in removing the axle seal from a Dana 44? These are the original seals - rawhide. I made a 'J' hook puller for the end of my slide hammer that I placed inside the seal, and no movement. Also tried a sheet metal screw without success. I read where some have used the end of...

Need some help on front suspension rebuild. According to the 49 service manual, to remove the spindle, the upper expansion plug is removed. Then drive the spindle out, which removes the lower expansion plug. How do you remove the upper expansion plug? My plan was to make a hole with a...

Sedan delivery rear fenders with surface rust, no dents, rust through. $200.00 plus shipping Located in Southern California. 1946-48 Send me your email if you want pictures. Thanks Warren

Set of (8) 29A-99A connecting rods 2.138 journal 3 3/4 or 4 inch crankshaft Worked performed at Al Hubbard's Machine Shop in Hayward, Ca. by Wade. $60.00 for the set. Plus shipping Weight is about 15 lbs. Shipping from 92885, Yorba Linda, Ca Orange County. USPS Flat rate box(es) or UPS...

(2) spring perches $40.00 for the pair. Plus shipping USPS flat rate box or UPS - buyers choice Shipping from Yorba Linda 92885 Thanks wga

Rear engine mount new, not installed. These are $32.95 from Sacramento Vintage Ford. $20.00 plus shipping. USPS flat rate box or UPS - buyers choice Located in Yorba Linda, Ca. 92885 Thanks, wga