Search results

What is the correct carburetor for a 1940 flathead v8?

Any recommendations on installing an electric fan to help with overheating on 1940 flathead. Would a fan help and if so what should I use?

What would cause coolant to leak from where the heat exchanger ties in to the crossover pipe on a flathead v8?

Anyone know what this is and where it goes. Came off a 1940 Ford Deluxe. Very thin and less than 3 inches long.

Can someone identify the part in the attached picture. Where does it go?[AT

I replaced window channels and felt on front doors. Window rolled up and down just fine until I installed door panel and garnish moulding. The glass now comes out of channel when I roll the window down about 3 or so inches. If I put pressure on the glass with my hand it will roll down as...

The front bumper grommets for 1940 Ford Fordor. One side of the grommet is wider. Does the wide side go toward the inside or outside?

There is a small gap on one side between the exterior door handle base to the car. The 1940 ford fordor door handles have a screw in the threaded hole in the handle base. When I tighten the screw it pulls the base flush to the car but handle won't release on its own. Is it too tight or is that...

Are the windows on a 1940 ford fordor deluxe suppossed to roll all the way done to where you don't see them or do they stop a couple of inches above the bottom of the door.

Does window felt/glass setting tape or anything go inside the metal glass frame for the rear swing out quarter windows on fordor deluxe?

The tube on my housing end plate is broken. Can it be repaired or where can I find another.

Putting 1940 fordor back together. What is best way to align doors?

Do you need a gasket where the clam shell bolts on to the transmission. The clam shell is two pieces.

Can someone tell me what the torque should be for a 1940 ford flathead flywheel to crank and pressure plate to flywheel.

Looking for a flywheel for a 1940 deluxe. Also is the 9" correct size for pressure plate and clutch disc?