Search results

Hi Everyone, I am having a hard time finding the right code for the Arabian Sand Light. This is for a 1928 Roadster. My local PPG shop crossed the Dupont code G8883 with a Mercedes color Peublo Beige.I sprayed out a test panel, but it looks more gray then tan (reminds me of clay). Anyone have...

Hi everyone, I was working on the headlights/taillights this morning and the switch on the steering wheel (where the horn button is) kind of popped up , is now just spinning around, I checked the clipat the bottom and it is still on OK. It looks like it isdisconnected fromthe rod at the top...

Does anyone have a diagram or some really good pic's of how the luggage rack adapter brackets bolt up to the rear bumper brackets? Any help would be appreciated!! Thanks, Jim

Hello everyone, Getting to the final assembly, need some help with the top. Does the vinyl top go over the visor or under. Right now I put the visor on, the vinyl over top of that, then the tack strip. Is this right? Thanks, Jim

Hello, I am having trouble installing the welting around the rear fenders. Everything fits well except the very back of both rear fenders. There is about a 1/2" gap between the body and the rear fenders. I think they are aftermarket. I will ry to post pic's soon, but has anyone else had this...

Hi Everyone, I have new glass for a 31 Tudor rear window. Is there an easy way to remove the old glass from the track? The old glass is already broken so I am not too worried about damage to it. Do I heat the track? Thanks, Jim

Hi Everyone, I bought a set of door and rear window channels kits for a 1931 Tudor from Bratton's (PN 31770 & 31820). In both kits is a small roll of rubber labeled " 'T' Rubber Window Glass Anti-Rattler for Inside Window Mouldings" and is made by Vintique Inc P/N A-45986. Not sure were this...

Hi Everyone, Sorry if this has already been answered. I did a search but could not find an answer. I am trying to put the spring and clip back on the shifting lever. I have the tool, but it will not fit down between the two rods holding the shifting forks (hope this makes sense, kind of...

Hi Everyone, I started putting the Universal Joint together today with a new bolt set. In the book it looks like the bolts should slide in from the front with the nuts on the backside, however I can not get the bottom one in, there is not enough space between the ****** and the joint cover...

Is there an easy or preferred method for removing the press in type grease fittings? I bought a replacement set but am afraid I will damage or break the old ones pulling them out. Is there a special tool? Thanks, Jim

Is there an easy way to check the fluid level in the rear axle? I have the 600W gear oil, not sure how to get it in? Thanks, Jim

I know this one has been beat to death here, but I am at a loss, and it may be my inexperience at using a dial gauge. I was following another thread on here http://fordbarn.com/forum/showthread.php?t=72124. I bought a dial gauge with a magnetic base from Harbor Freight. However, I can not get...

Hi Everyone, I have a new tie rod, but can not find instructions in any of my books on the best way to change this out. Anyone have instructions or a link I could use? Would be greatly appreciated. Thanks, Jim