Search results

my steering has a lot of slop at the steering wheel, does anyone have a suggestion where to get a new or rebuilt box

I need one original wheel to match my other 3 wheels. 1955 fairlane club sedan. I am also looking for a hood latch. Thanks Jim

I am installing a new original type interior in my Club Sedan. On the back of the front seat there is a piece of stainless trim that is apparently to be attached withe 5 clips. I don't see how to put those clips in after the seat cover is pulled down into place. I need to know what type of clips...

I am trying to install in 55 club sedan. What am I missing? When I slide the column over the steering shaft there is a space between the shaft and the I.D. of the column. Also when I put the steering wheel on, it hits the turn signal housing. Is there a roller bearing or bushing that goes at the...

I am putting a original rebuilt trans and torque converter back in my 1955 fairlane. Do I have to put fluid in the converter before bolting the transmission in? I didnt think about this until I after I bolted the converter and bell housing to the engine. P.S. what type fluid to use? Thanks Jim

I am putting a Mummert intake and holly carb on my 1955 club sedan with a fordo trans. I would like to know what others have done with carb and trans shifter and kickdown linkage. Thanks :confused:

I need the rear armrests for my1955 fairlane club sedan. Condition not important. I dont need the metal ashtray inserts. My main concern is the plastic part needs to be good and solid, so I can refurbish. Thanks Jim 805-459-535four

Does anyone know where I can get new hood latch springs? 1955 fairlane. Both of my springs are broken.

I am trying to figure out what type of trim clips go where. most of my clips were rusted or missing. Does someone have a diagram or picture of where they go. When I look at the retail catalogs I just seem to get more confused.

I need a new radiator for my 1955 fairlane club sedan. I would like to hear about any experience you guys have had. Fit, mounting, hose hook up, ect. I would like to get a replacement that would bolt in like the original. I dont care if it is alum or brass but I would like to keep the cost...

I know there has been discussion about rebuilt distributors. does someone have the length that the correct shaft should be from the block mating flange to the tip of the shaft? I bought a rebuilt dizzy from Napa a year ago and had to send the old one back. 1955 272 built to a 292 spec...

Was there a standard color for the gravel pan on 55 fairlane club sedans. or, were they body color. Thanks

need the arm rests. anyone parting a 55 with decent armrests I will re-cover.

need a sun visor with a good triangle shape mounting plate and rod