Search results

http://www.ebay.com/itm/171310426523?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

I'm thinking of maybe selling or trading my 32bb 1.5 ton dually flatbed. Where would be the best place to do this? H.A.M.B.? Thanks.

http://www.1959bhsmustangs.com/VideoJukebox.htm

Has anyone added corn head grease in addition to the gear oil to their transmission or rear end?

I can not remember who it was that had fuel pumps for the 4cyl. Macs and the other suppliers don't have the 4cyl. pumps, just the rebuild kits. I rebuilt this pump over the winter and it works fine. The problem is that once in awhile it will leak. It's not coming from any fittings, but from the...

I keep getting diff. responses as to the oil cap. on my 32 bb 4 cyl. Some say 4qts. some say 5qts. I have know markings on the dip stick, and would like to know for sure. Thanks in advance.

I had it listed on my favorites, but now I can't find it. I need the brake light switch which has a mounting screw on each side of the drum. Which of course mounts to the trans. Thanks in advance.

Not sure of dip stick. 32 4cyl. BB truck. 4qts. or 5. thanks.

Just got my 32bb back from Portage trim in Ravenna, Ohio. He put in a new headliner, kick panels, and flooring for a very reasonable price. Besides being a nice guy, he's also a perfectionist. He even installed a little bag on the kick panel for papers. This is not a commercial but people bring...

Would anyone know where I can get the one piece rubber floor covering for 32bbb truck? It's the 1.5 ton, but i'm assuming it's the same as the pickup. Thanks.

Does anyone know where in, or around Ohio I can get metal bed strips 117" long? I can find them, mostly out west, but they wanted 187.00 to ship eight strips. Because of the length they have to go freight. Thanks.

I have new rubber bumpers, dovetails etc.. Doors fit and close nicely. hinges and pins are tight. Everything is fine until I get on a bumpy road, and then they rattle. Not too bad, but enough to make you pay attention. Is this just something I have to live with? Thanks.

http://forums.aa-fords.com/viewtopic.php?f=1&t=3412#p18227

Hey guys, I got my truck running today after a total rebuild. New pistons, rods, valves everything. The truck is spitting at idle out of the exhaust. I feel that the engine timing is a little too much advanced, by the way that it cranks over. I used Macs "nu-rex" tool to set the timing, by the...

I'm looking for the metal slats (stainless) that fit between the boards on a flat bed. I need eight, no less than 117" long. Thanks.

32bb 1.5 ton flatbed dually. I am running about 50lbs. on 6.50x20 What do you think? Don't haul much with it but maybe couple yards of mulch. Thanks.

What do you think? I have a new wiring harness, conduit, sockets etc. The way that was designed is an open circuit (short) waiting to happen. where the conduit goes together with the socket at the headlight bucket, there's not a lot of room for error. I'm thinking to solder and heat shrink...

What happened to the joke of the day?

has anybody had the problem with the stainless bolts that hold the headlight bar (purchased from Macs) being too short? I just thought I'd check before I call them tomorrow. Thanks.

I'm assembling my32bb flatbed dually and don't know for sure if there is supposed to be fender welting between the fender and running board. Also between the board and frame and the fender and frame. Thanks ahead of time for your input.