Search results

Nice sedan rear fenders good bead and no rust damage $250 each $500 for the pair no shipping pick up in Kelsey near Placerville California.

Radiator and shell the radiator holds water and drains nice. Pick up only near Placerville N California $350

My question! is this supposed to pivot? where I'm pointing this part is powder coated, I think and solid.

I bought tires and tubes off craigslist about 6 years ago they were all in plastic bags. When I got home, I stuffed the new tubes inside the new tires and aired the tubes a little so they wouldn't wrinkle and crack. Stored indoors the made in USA tubes still cracked zero miles never mounted I...

Working on a 7 tooth and noticed the upper steering column bushing came with screws but no screw holes . Do I install the rods and anti rattlers and drill and tap ? Its going to be a tight fit .

After spending hours sanding all the bumps and nicks from the toggle shafts and actuating arms key ways the spring was simple ! A little grease slip the spring on then the arm tap tap hook the spring well almost that easy . My special tool made the job easy took seconds to hook the spring .

https://www.msn.com/en-us/autos/enthusiasts/the-day-the-la-auto-show-went-up-in-flames/ar-AAQGUJq?ocid=msedgdhp&pc=U531

A Fedex shipment away from becoming a roller. Only took ten years but is on the front burner now future resting place for a 1929 standard coupe .

Working on a 7 tooth steering assembly heavy paint black / orange / yellow after a couple of hours paint is falling off . parts on the way so clean and get ready for paint . The bearings failed because of heavy waxy grease in box no lube getting to bearings .

When I removed my rear brake backing plates bolts they lacked cotters . I now know why they were the wrong nuts too tall to line up with the hole in the bolt .The nut on the right if the photo shows .

Working on a rear brake assembly things were going to smooth . I put the E-brake return spring on the wrong lever I had 4 springs two silver and two black .

What tool is used to remove seal ? I don't want to damage the bearing none of the pullers I have will fit . 28 - 29

I finally started back on my brake job decided to tackle the rears . What a surprise I was able to remove the axle nuts with my fingers . A little wiggle and off came the brake drums both sides were loose nice paint on the backing plates and carriers everything was nice and clean . The drums...

Seems like a good price if you could climb in and drive away . https://sacramento.craigslist.org/pts/d/valley-springs-1931-model-aa/7373376017.html

Just some random old photos trying to post .

today I'm working on a 28 - 29 gas tank just cleaning it up and a little sanding. I think I'm going to sandblast and prime there's little to no work left except paint . Also a photo test this the tank I'm replacing too many repaired bullet holes and its been lined I just don't trust it . But it...

Working on a 29 standard coupe my old project that was side lined . Cleaning up a nice gas tank decided to test fit before I went any farther . Went ok had a little problem with welt needed more hands but felt good to working on my project again . Bats and mud dauber nests and spiders just like...

https://sacramento.craigslist.org/cto/d/fair-oaks-1930-ford-model-commercial/7127090684.html

I can't say much for the paint job but for $7500 you get a driver with what appears to be a nice body . https://sacramento.craigslist.org/cto/d/1930-ford-model/7065712283.html

Glacier Point Yosemite its a long ways to the valley floor off the end of that rock.