Search results

I spent a lot of time money bringing her back to 99% original. Need to call if interested, I am not real savvy with computers. I will try to post a few pix 509 995 5523

I bought a vac boost fuel pump for my 53 vic and now need to know what vac lines go where? Thanks in advance

Excellent set of 41 Washington plates. 509 995 5523

I have a Ford 60 offered to me but I have no idea as to what I should pay for it or what it would be worth. I have a few parts left over from my 53 and have no clue if any of the 239 parts will even fit. Any info appreciated Tom

all steel, 239 , this car is done and ready for new owner. to much done to it to list.

There are 2 vacuum ports on my 53 Vic wiper motor. Why 2, and what would be the connections? Thanks,

How much vacuum should I have to make my wipers work on my 53 vic? They don't want to work and I seem to have a very low vacuum but how can I get it a little higher? The port under carb was plugged up so I cleaned it with an 1/8 drill bit and that gave me a slight hint of a vacuum

Where can I buy an electric 6 volt wiper motor for my 53 vic? Thanks

I am installing new hg and see some have 3 large ports in the rear and some have only 2. My block and head indicate they should have the 3 but the kits only have the 2, [felpro] All this for my 53 stock 239 car. Asked my dealer and he said to put a hole in it for the third port. Some how, this...

Ghia, coupe, stored for 29 years, absolutely a perfect car in like new condition. 21597. Original miles, not even a bug mark on the hood. trunk looks like it has never been used. Factory c4 ****** and V6 engine. Interior is perfect. Still has the original tires. I could not post pictures, so if...

Will a heli coil work for a bad head bolt?

We timed my 53 with a 12 volt timing light as per the book but the starter just does'nt want to roll it over fast enough for a good start. It eventually will start but just sounds like a dead battery while cranking. Will retarding the spark solve this, or will have to pull the starter out...

Were can I buy a 6 volt pos gr volt meter to mount below dash? Thanks

I am ready to install the front seat in my 53 Vic and see a wire from one side to the other for linkage I think. Is there supposed to be some kind of return spring attached? There is a peg sticking out in the center with what looks like it should have something attached like a spring or...

It is a nice, all original steel, new paint, stock running gear with a 239 stock engine, ex w/headers, front disc brakes new tires, elect cooling fan, no rust, new brakes. 2 years work getting it to great condition. I am out of room, call for extended details of what all has been done 509 995 5523

All new inside, bench tested 110 lbs comp on all 8, 25 lbs op at 250 rpm. Also a used 239 needs cleaned up. $400. both engines are 8ba from trucks side distributers 509 995 5523 I can rig for shipping,

All totally rebuilt with all new parts, I also have a 4 sp truck transmission, clutch that goes with it. ready to ship. Test stand run and had 25 lbs oil pressure, 110 lbs comp on all 8 cyls at 250 RPM

I have an automatic transmission in my 53 and am asking if all the starters are the same, one in the car now and a spare from a standard trans parts car and want to get it rebuilt and store on shelf for my 53 Thanks

What bolts do I need to bolt the front seat backs together in my 53 Vic?

I need 1 set of headlight rings [door] for my 53 vic 509 995 5523