Search results

Looking to build a motor with this crank. My question, can someone tell me the stock measurement of main and rod caps? So many have been filed down. Gonna be a babbit motor. What is a acceptable cap measurement?:confused:

Model A engine Bore .125 0ver Crank and rods .20/.20 New babbit in mains New babbit in rods New bushings in rods New valve guides ( 1 pc.) Big intake valves (1.73) New S.S. valves harden seats in block New springs New piston and rings New crank and Cam gear reground touring cam flywheel cut and...

Bore; .100 over Mains; .010 Rods; .010 Counter-balanced Crank(weld-on) Stipe 340 cam C-head Large intake valves(1.730) Balanced assembly All new babbit, harden seats, gaskets, head studs, and new gears. Any questions. call 567-207-8799

I got a motor with a bore of .060+. It might clean-up .100 over. If not .125 over. Do I spend the money to bore and seat the motor. I got a nice .010/.010 over crank for it. This block crack-free. Also thinking about big intake valves. What do guys think? Thanks. Rod

Want to put a C-head on my A. Is there gonna be any problems?

Can someone help me out and put a price on my 392 hemi? I have had this motor for 20-plus years, it's standard 4.00 bore and the motor does not turn over anymore. Complete from oil pan to carb. It will need rebuild.

1930 motor, new pistons and rings, harden seats with new ss valves.All new babbit and new bushings in the rods. The crank is .010 on the mains and .020 on the rods. could deliver to chickasha. The price is 2000 for the shortblock, or 2500 for a running motor. Call Rod at 567-207 8799

Check out Criags list, All new, under Findlay, Lima Auto parts, Model a ford

For more info, Go to criaglist (Lima-Findlay) under model a in autoparts. Can't seem to upload pictures here. Thankyou you for looking.

Hello, I'm putting a B-cam in my 29, where sould I set the vavles??

Hello, I got a fresh rebuilt, I'm running a B-cam, which would be the better head, A Winfield or a C-head?

1928 motor #2119343. Block .060,crank 20/20. New pistons,rings. New crank and cam gear, a set of new head studs (need to put your head on).Modern vavle set, single loc tappets. Motor is ready for your head(gasket included). This motor has all new babbit, been linebored and has hardern seats...

Would like to run a oil line to my center main,I've seen pictures, what tools do I need, (drill bit size, tap, fittings,line size) Does It matter where you drill the hole?

Can someone help me with this? Is it good,bad or what.