Search results

Hello guys On a seven tooth steering box will the worm gear come out the bottom of the box ? I am trying to avoid pulling the whole column out .

I have my head off the 28 , I took the upper coolant neck off, I noticed there is about 1/4 inch of gap or more between the (new Macs)water pump impeller and the inner impeller surface in the head, should this not be closer ? It does run hot but there are lots of other reasons for that , there...

Hi all, I am going to re-ring my 28 A , I pulled the head today, there is a lot of lateral movement in the valves , should I bother replacing the guides ? how much movement should there be or what is allowable ? not being cheap, I just dont want to disturb things if not needed. Dave in...

What causes a speedometer to be hard to turn ? I lubed and cleaned it as much as possible , I think it pulled cotton into the gears or something . Looks like a cotton wick oil packing near the main shaft.

Hey guys, I put a reman generator on and it shows a charge on my ammeter at idle and higher rpms , It shows discharge when the headlights are on idling and reved up, Is this normal ? Should I swing the third brush a bit more ?

28 A Coupe , is the headliner and sides material the same as the seats ? I am doing it all from scratch myself and want to pick up material monday. I want to use medium grey color . If you know roughly how many yards I need that would be great too.

Hi guys, I have some technical questions, this car will be burgundy with black fenders What color should the intake manifold be ? Carburetor Color ? Fire wall and under hood (bottom side) color ? hood shelf color ? hood hold downs color ? where should the speedometer cable enter fire wall ...

I acquired a running/driving 27 T chassis from a rat rodder so I decided to build a doodlebug, I am trying to put in a 28 A trans behind the T trans, how did they couple the them together ? I found a spare A rear u joint which fits the A input shaft and am thinking of welding a short piece of...

Found these in my shed and cant figure out what they are , does anyone know ? there is rubber in the rounded parts and the nuts/bolts are coarse thread hex not square the studs are fine thread. Casted in it says pat. nov 20-11 BAIR 423r and 423l Dave Sebastien Saskatchewan Canada