Recent content by winchester

Hi Fellows,took your advice and it worked. Thanks John

1940 ford

Hi. I was the fellow with the front wheels dragging, today I removed the wheel bearings ,the bleeders and released the brake adjustments the hubs will not pull out over the brake shoes. Any idea how to get them off. Thanks John

Hi. Took my 40 Ford out for a spring ride, when I put back in garage it would not roll ,jacked up rear and wheels turned free, jacked up front and the wheels could hardly turn ,both wheel. I thing the problem is with the master cylinder. If some one could help me with a solution I would like...

Hi I have a 1940 Ford with with stock 16 inch biast tires, I would like to know what size Radial tires I should put on it. Thanks John

Hi. I would like to know if there is any fuel company that does not have ethanol in it? Thanks

Hi. I'll will be over one these days to see your Studebaker and your backyard buddy,I saw you the other day when I was running around in my 40.

Hi I'am back, still working on my 1940 ford charging problem. Can any one tell me how many wires should be attached to the BAT terminal on the voltage regulator. This one has two and when you remove them and measure to voltage they both have 6.24 volts. Thanks Winchester

Hi. I checked the voltage at th regulator the BAT was 6.24 the field was 0 and the arm was 2.24. Thanks Winchester

Hi. I did what you told me and disconnected the ground on the battery, and the engine quit. I had the generator and voltage regulator in the shop they told me that both of them are working fine. What next. Thanks

Hi. Took my 1940 ford on a 20 mile trip today, thought I had the charging system fixed. Put the car in the garage ,shut it down, did not have enough battery to turn the engine. Need some help on trouble shooting system. Thanks Winchester

The voltmeter in dash has red,amber,green ,red,with battery charged it never gets out of the amber the reg and gen are fairly new. Thanks

My battery keeps going dead on my 1940 Ford,It has a stock system with 6 Volt and pos ground. Can someone help me with some trouble shooting ideas. Thanks

Hi. My 1940 ford needed the dash bazel replaced, I bought one from Dennis Carpenter it had a gasket and new clips. Do I have to take the Dash out of car or the isterment panel to replace the bazel? The clips look like they have to put on with insterment panel out. Thanks Winchester

Hi. Replacing my spark plugs in my 1940 Ford it has Champion H 10 the only thing my NAPA store has is H 10C. What does the C stand for and will they work? Thaanks Winchester