Recent content by whb52ford

Looking for a used 52 Ford car sill plate for a 2 door Drivers side. Ruined mine getting a stuck screw out. Ocala FL 34481

For many years I would hone and replace the rubber cups. They wanted as much for the cups as a rebuilt cylinder so I went that route. I no longer have the original. I don’t know if you can even buy the cups anymore. I have no problems with the other 3. Why just this one? 4 in 2 years.

I drive the car several times a week. These are purchased rebuilt cylinders. The link above did not work, or I didn’t know how to do it

Thank you. Before I put in it tomorrow I will take it apart and clean it. I have been using DOT 5 for many years.

Tomorrow I’m going to replace the drivers side front wheel cylinder for the 4th time in two years. These are purchased rebuilt wheel cylinders. I get about 6 months. What could be causing this? The other wheel cylinders are fine. Stumped

I think that is my problem. I think I’m missing the snap ring because it moves a lot. Thanks for help

Could someone explain to me more about the driving gear on the drive shaft moving forward. When I stick a screw driver in the hole from the turtle, I can push the drive gear all the way forware and back. Probably more than an inch movement. Is that the problem?

Would you explain that more?

Where can I get a longer speedometer cable?

I have a 31 Tudor with F150 transmission. Everything was working fine till I decided I wanted to replace my speedometer. I received a different rebuilt speedometer back and I put a new cable from the Model A Medic in. It was fine for a couple hundred miles then the speedometer started jumping...

I 3D Printed one. If you know someone with a 3D printer I can send you the file. It's about 4" high. I think I have a plan, but until proven I won't post it using relays.

I have looked at this for many years. Never seen a complete one. What I'm interested in is the instructions to make this work. June 1950 Poplular Mechanics Three-Color Stop Light Signals Driver’s Action “Motorists following a car equipped with a three-color stop light know exactly what the...

I bought 5 tires from Cooker. The tubes they sent me are #864001. After an extended phone call he admitted those tubes are heavy duty (as stated on box) and not radial tubes. It appears they have quit selling radial tubes. 475/500-19.

I can't find a radial tube for 475/500-19. Cooker finally admitted they sold me a heavy duty tube that was not radial. #864001

Anybody have a breakdown on how this is put together. I came across a set of chrome rings, but not sure how they get attached.