Recent content by WaltG

Thanks everyone for your input! I have the original NOS metal cartridge style shackle studs but I do not have the special tool needed to install them. I bought the "hot rod" style shackle kit but they do not include the 7/8" spring eye bushings. My thought was to insert a steel sleeve into the...

I was wondering who sells the steel sleeves that fit into the leaf spring eyes? The sleeves are 7/8" OD x 3/4" ID with a wall thickness of 1/16" and an overall length of 1 3/4" and 2 1/4". Thank you! Walt

I need to shorten a set of '33-'34 brake rods to fit my '32. Do I measure from the center of the round eyelet to the opposite end of the rod or do I measure the overall length of the rod? I know what the lengths need to be, but I do not have any old rods to use for reference. Thanks!

I have one other problem concerning the gear box. When setting the pre-load on the worn gear, what would be the average thickness of gaskets/shims needed? (I am using the original upper bearing cup and thrust washer) My number came in at .060" This number is far above the spec given in the Ford...

Thank you everyone for responding to my question. With your help I was able to solve my problem.

I just finished overhauling the steering box on my '32 Ford. When I Bench tested the box I went to install the pitman arm and noticed that it will only fit the shaft either at the 4 or 7 o'clock position. I assumed that if the steering shaft is at "high center" (half way between the 3 1/4 lock...

I would like to upgrade my '32 Steering Sector Housing with the 1936 needle bearings and oil seal. Who offers this service? Thank you!

Thanks for posting the info!

Thanks! I got my answer! :)

I need to repair the damaged threads in the "oil fill" hole on a '32 Steering Gear Box (car) can anyone tell me what the correct size tap/thread chaser I will need? Thank you in advance for your info. Walt

Thanks Everyone for the information!! It is greatly appreciated! Walt

I am going to overhaul/restore the steering column lock mechanism on my '32 Ford. Has there ever been any printed material/information on this subject? I would appreciate any information, ideas, experiences, etc. Thank you in advance

Wanted for a '32 Ford: Steering Sector Shaft Housing. Must have Part #B-3583-A stamped on the part.

Looking for 3 NOS or Mint used draglink balls/studs for a 1932-'34 Ford car. Ford part #B-3311

Is this a piece of the lower chanel? If so, which area?