Recent content by Ron McIntyre

28 A lights won't work. What can be the cause. Starter turns engine Over.

New battery cleaned terminals no lights horn. Generator was bench tested with cutout all good. Tried reversing cutout direction. Only 2 feet and cannot be reversed. What can be wrong

Original brass rad in good condition. Has made in Ford Ontario, Canada tag. Photos available.

Thanks. I will try your ideas

having a problem installing the belt on my 28. The generator is on but the belt does not want to go on the fan pulley. The belt is the 43 inch old stock.No room to take the belt off around the fan blade, bends the fins . Need some ideas.

Has repro exterior spring cover. Repro straight and bent starter rod available

Is it possible to post photos from cell phone.

Nice condition. Photos available.

Nice condition steering wheel. Photos available.

Neville fatman sliding steering wheel in very nice condition.Selling my T .Photos available.

Will try turning cutout around. Did put with feet facing as photo indicates.Is it necessary to disconnect the battery before disconnecting the cutout and replacing.

Installed new battery. Brake light is not on. Putting lights on goes negative and bounces back and forth. What can be the reason. Replaced cutout with diode type.

Need complete needle adjusting assembly for a MS Carb. Hope someone has one

Thanks everyone. Like the great photo.

What is correct way to install cutout. Seems there is 2 ways.