Recent content by ripper57

F-1 steering box is too big and ugly ! also too heavy. I used GM pump and GM box (dialph) works great and looks good ... I made a adapter with a scrap piece of 1/2 plate. ripper57

I installed power disk brakes on my 1950 mercury and have a problem. I have a great pedal with the engine off but running the pedal goes two inches off the floor.I have 20 inches of vacuum and power bleed the brakes several times. I only get a tricle of fluid off the rear bleeders but the front...

I need both inner front fenders and both fender supports (front) for a 1935 to 1937 pick up. Any one have one or all contact me. I have the fenders. thanks, ripper ps any leads to after market above parts also helpful...

ripper1957@hotmail.com

I have 1949 mercury 15/5 . I get $50 each plus shipping. ripper

I believe it's a cast iron from a dump truck. It's similar to the 49-50 mercury but the merc. is steel. Then trans. bolts on but it takes a early ford (1937 to 1948) or merc. The starter plate bolts to the bell housing. Without the plate the bottom third of the flywheel is visable. Let me...

(1) I need the starter plate that the starter mounts to. It bolts to the rear of the engine next to the pan. (1949-1953 flathead) (2) I am thinking of using a 1932 grill on a 1935 ford two door. I also am considering using 1935 pick-up front fenders as they cost less than the car fenders. My...

on the righr side(passerger) just below the front freeze plug on a 292 engine there is a drain plug ? When I removed it to install a second temp. gauge sending unit nothing came out ! No water, no oil, nello !! It looks clean, no rust. upon futher inspection there is about 3/8's inch open space...

I used a T-5 from a mustang V-6 but put the S-10 tailshaft to move the floor shift forward away from the seat. Been driving it over a year and love it ! (1954 Sunliner) ripper