Recent content by RH

  1. R

    50 coupe hard steering

    My 50 Ford coupe is very hard to park. Are there any tricks to help?
  2. R

    1941-1948 Ford/Mercury Passenge Side Convertible Door

    Wanted- Front anti shatter rods for a 1941 Ford. These rods connect to the front cross member and the back of the engine. They should be 23 1/2" long. Part no. 11A-6044 royce36@aol.com 818 889 8665
  3. R

    parting out 41 ford 4 dr sedan

    Wanted- Front anti shatter rods for a 1941 Ford. These rods connect to the front cross member and the back of the engine. They should be 23 1/2" long. Part no. 11A-6044 royce36@aol.com
  4. R

    Wanted 41 chatter rods

    FOUND THEM THANKS Wanted- Front anti shatter rods for a 1941 Ford. These rods connect to the front cross member and the back of the engine. They should be 23 1/2" long. Part no. 11A-6044
  5. R

    Rh

    Wanted- Front anti shatter rods for a 1941 Ford. These rods connect to the front cross member and the back of the engine. They should be 23 1/2" long. Part no. 11A-6044 royce36@aol.com
  6. R

    Parting out 1941 Ford

    Chris--I need the anti chatter rods off of your 41. The rods run from the front cross member to the rear of the motor. They should be about 23 1/2' long. royce36@aol.com or 818 889 8665
  7. R

    1940 rear radius rods

    Hi--How long are these? I want too fit them to a 46 Ford. RH at royce36@aol.com
  8. R

    Falcom transmission mount

    Hi- I need the special bolt that goes through the round rubber donut on the trasmission rear mount or the compete mount with the bolt. This is for a 1963 1/2 - 1964 Falcon with the 260 engine and automatic. Please check your old parts. royce@aol.com
  9. R

    Vibration 1936 1/2 Falson

    Thanks for all your help. I'm replacing the rear trans bushing today. RH
  10. R

    Vibration 1936 1/2 Falson

    Hi I have a vibration in my 63 1/2 Falcon V8 260. It feels like a U-joint. but that has been checked out. U-joints, drive shaft, rear wheel bearings have been replaced along with front end ball joints and tie-rods. Drive shaft angle is right on within a 1/2 of a degree. The tires have been...
  11. R

    Noisy brakes

    Hi. This 1930 Model A belongs to a friend. The front brakes have been noisy all time time he has owned it. It has modren lining and steal drums.and floaters. Adjusting did not help. lining and drums look good. Any ideas?
  12. R

    Noisy brakes

    Hi. This 1930 Model A belongs to a friend. The front brakes have been noisy all time time he has owned it. It has modren lining and steal drums.and floaters. Adjusting did not help. lining and drums look good. Any ideas?
Back
Top