Recent content by myaddress2020

I always starve it for gas when i shut er down. What do u think about this leak from choke rod entry point?

Shouldnt it not get pSt the shutoff valve anyway?

I am getting fuel leaking from where the choke rod enters. This is surprising since there is a fuel shutoff to prevent this. Does that mean i have a bad shutoff valve?

Hi all. I bought a set of shocks from I think it was gaslight a few years ago. Anyway I had noticed drips under some of them and was going to this winter see about fixing why they leak. So looking through some catalogs they sell rebuild sets and fluid. Then I see for sale is rebuilts I guess or...

i took it to a friend today who has a sthesiscope and he thinks its a broken piston pin in the 4th cilinder. we looked in the trans inpec plate and he didnt think it was wobling so he thinks the rear main isnt it. it doesnt make noise in retard only in advance.

i hope your wrong, this a brand new rebuilt engine from schwams in PA

ok so i put the timing pin in while it was running and it wasnt the gear slapping back and forth. there is no in and out movement on the water pump shaft and i touched the distributor shaft and it went up and down only slightly. still not sure...

hi all i wonder if anyone can give me some insight into a peculiar knock that started on yesterdays run. while i was going along a steady knocking started. engine acted normal. when i stopped the knock remained but it was not a steady one. when it is at idle it is an unsteady knock. when throtle...

no not halogen just the brighter one of 2 in the brattons catalog. incandecent.

i am using a new wiring harness, a new stop light lamp which is the brighter one in the brattons catalog. i keep blowing lamps. the lamp will work but at some point in my travels its shot. no other lamps have blown, and ive gone through 2 stop lts so far. my next question to myself would be what...

you fail paul! jst kidding. i found how it goes in the brattons catalog but thanks everybody.

i gotcha. i was pouring mine in the top of the trans with the shifter still off. so les A. said 1 and half pint in trans, and 2 1/4 for rear?

nevermind

does anyone know how to use the 3 tube rivets and rectangle plates that are for attaching the shifter plate to the floor bourds? thanx

between les andrew's book and the brattons catalog there is conflicting values. can anyone tell me the correct volumes of oil in the rear end and transmission please? thank you