Recent content by Marv 119

Thanks It looks like i have nors model a king pins. I think kinkpins are used for getting a afro. Marv

I have a new set of kingpins and dont know if they are for a 32 or a model A. Is there a way to tell? They are wards riverside part no 61-4213. Realy dont want to buy more if these will fit. Thanks Marv

Thanks Kevin That answeres my question.I do not have a glass fuse holder so i plan on a circut breaker. I think i will start with a 25 and see how that goes.The pickup is all origional . The headlight switch shoirted to ground and burned up the wiring because of no fuse so i want to preve4nt...

I really have no clue as to the wire size.I purchased the harness from Dick Spadero and it came from California. It has sealed beam adaptors in it now but i am planning to put stock type bulbs and reflectors back in it as soon as i find them.Really have no intention of driving it in the dark...

I am installing a new wiring harness in my 32 pickup.The scematic shows a fuse between the amp guage and the light switch. I thought of just using a circut breaker but dont know what amp rating to use. Any ideas? Marv

I have what i believe to be a 1926 coupe that i recently purchased. It has only two foot pedals? plus foot throtle, On the transmission where the brake pedal would be there is a short arm that has a linkage that hooks to a earon the high low pedal . Anybody ever seen this? The rear brakes are...

No more pics yet. I hope to get the motor numbers and a few more pics the end of next week. It is in a garage that i don't have ready access to. Marv

I had a car do the same thing many years ago. We finally figured out the wires on the coil were reversed. Marv

Andy Email sent

Thanks for the info.I guess i will have to wait as i won't have access to it for a while.I was just hoping to get started on getting title info and need to know for sure the year. Thanks Marv

Can anyone tell by these pics if this is a 26 or 27?As of now these are the only pics i have.

I have a 28 pickup i recently purchased and the dash boardhas the chin like bump in the center.I thought i was told that was only roadster that used that.So do i have the wrong one? Marv

Jerry I will look at mine tomorow .Whoever was working on mine was very very welder happy and not very good at it either.Kinda looks like the pidgeons roosted above it.The ends may be savable tho. Thanks Marv

Thank You I figured out the one i was looking at will not fit.Mine has tabs for rivits through the side of the rails also.The one i found had only upper flange and lower flange rivet holes.So i will keep looking. Marv

Will Any 32,33,34 ford rear crossmember fit in my 32 pickup? Thanks Marv