32 pickup rear crossmember

I can't speak to the '33,'34 part of the question but there were two slightly different widths for the '32 cross member depending upon whether or not there were reinforcements attached to the inside rear of the frame as it went over the rear axle.

Charlie Stephens
 
Thank You
I figured out the one i was looking at will not fit.Mine has tabs for rivits through the side of the rails also.The one i found had only upper flange and lower flange rivet holes.So i will keep looking.
Marv
 
Hi all; I have grafted 33/34 crossmembers with 32 frame ends, and lowered the 32's chassis about 2'' in the rear. But you need to start with a 32' rear crossmember. Newc
 
If it would be of any help I have one that was torched out of the frame. Except that the ends were cut off it's in good shape with no rust pits or cracks in the spring area. If you have good ends it could be welded in.
 
Jerry
I will look at mine tomorow .Whoever was working on mine was very very welder happy and not very good at it either.Kinda looks like the pidgeons roosted above it.The ends may be savable tho.
Thanks Marv
 
You must log in or register to reply here.
Back
Top