Recent content by jdpaxton

Educational to say the least to get closed rumble lid to match proper height of reveal molding of quarter panel. This is not a hinge adjustment cure. Closed it is at least 3/4" too low at rear edges. Front seems correct. I learned that regardless of vendors saying coupe and roadster hinges are...

Thank you. How tall is the original coupe panel please?

What are the differences of the lower deck lid panel between the coupe and roadster? I see repair panels are different. I need the height of either or both coupe and roadster please.

thankyou

Looking for a left reinforce brace for x-member 1932. I also need the rumble lid hinges cast with numbers B-47430 and B-47431 for std. coupe.

There is no number on the gun only Alemite Lubricator and Alemite MFG Corp. The grease gun and crank/lug wrench extension are the last items I need to complete the tool kit.(I hope)

thanks. The Model A and 32 seem to use a gun that is harder to find and usually in poor cond.

I need the left leg brace for an original mid crossmember and did a google search. A couple of folks advertised that they make them but they have disappeared. Anyone know of repro`s of the originals out there?

I can`t seem to locate an Alemite grease gun with a good to decent bright finish. Anyone have experience taking one apart for plating OR? Looks to be cadmium satin.

Thanks Glen. Actually my points are like shown but a separate copper strip, is sandwiched on the brass post with 2 tails, one to each point set. The brass post I am referring to, is the one attached with rivets to the contact mounting plate. The pic you sent is a great repair to the hot lead...

Repairing a crab cap distrib and the first thing I spotted under the cap was the broken copper connector between the 2 points and the brass post for the hot wire. This is made from .010 copper sheet. Not impossible to find but to replace the rivets etc and insulation seems excessive. Anyone have...

I am looking for this extension bar. Has the 1/2 round end.

Wish I had bought one of the green ones on ebay.

And there is another one very similar to above but has rivets holding the vertical body together rather than the crimp. Knob a little different as well.

I am just finishing up a collection of the included Ford tools with the 32 and just found the cast and forged ASMC jack. This was the "Other" jack as shown in the 32 book. I have been watching for one for a couple years and the very good as found unrestored jacks are green and not black. The...