Recent content by feelsharp

6V coil should have a resistance of 1.3 to 1.6 OHMs. Some times coils are marked incorrectly and following battery ground does not work. Snyders sells a tester that plugs into the dissy and coil and indicates correct or incorrect wiring regardless of coil markings. I have had NAPA coils that...

Mount your toggle switch on the gear shift, it's out of sight and handy to operate T/S as you down shift for corner or upshift coming out.

Re: Why don't some of the "High Rollers" mfg a good low pressure fuel pump??? Fed Mogul Carter pumps P60504, 2-4 psi @ 12V, 1-2 psi @6V or Carter P60430 4-6 psi @ 12V, 2-3 psi @ 6V. Runs either P or N ground, pumps best on N ground. If on P ground car, isolate pump on rubber hoses, run N wire...

Thanks for your comments guys, it will get done.

Yes, Lee, I have the rubber bullets on the front of the pumps.

Just completed a V8 60 install in a stock appearing 26T coupe. Am happy with the results with a 4:1 diff and T-5 ******. Having a real problem solving a leaking water pump. Have trued up the body on a lathe, hand surfaced the rear face of the impeller on 500 crit paper on a glass block...

For a ****** use a T5 available a reasonable cost and offers 5 speed with 5th OD. Bell adaptors are available for T5 to V8 60 engines.

The engine number also appears on the top of the right side frame rail about opposite from the parking brake lever on the left side. The motor number thus becomes the VIN number.

I've driven 500 to 800 mile tours in a '15 T and 2000 and greater mile tours in larger cars but with model T's in attendance. We follow tour routes selected by the organizers, very seldom high traffic roads and cruise along at 40 or so MPH. We do not parade, we leave plenty of space between...

There is a legal way to do it in Ohio if you want to work through an attorney. I did it on a 1914 car I purchased. Attorney makes a case that you have owned the cars for xx yrs, local people have known you owned the car, etc and presents a report to a county judge. Judge issues a statement to...

Applied new rubber seals to side and rear windows and pushed hem into place. Fit snug, but certainly not water tight. Would a little silicone sealer be of good use here?

Always use flaps! I place tube in tire with valve stem 180 degrees away from the tire fabric overlap. Some say this improves the balance--find the overlap by running the back of your fingers around the inside of the tire. Then I inflate tube to let it unroll and get it seated in the tire--let...

Snyder's and most other "T" parts houses sell them under the name of head savers.

Yes, you can do that, but be sure to add a little silicone around the wire, you can't squeeze the rad tube enough to eliminate a leak if installed this way. I just hang mine on the overflow tube in the neck of the rad, in a couple of years they're gone and I hang another.

ws, Do not know of Yockeys in Wadsville