Recent content by F.M.G.

So far all I find are made overseas (JUNK) I will keep looking.

Where can I get some good front engine mounts for a 1950 ford car. They mount to the bottom of water pump. Speedways last about 1 year. Thanks, Mike

Any one know of a good flathead rebuilder in the Houston, Texas area. The shops i have called dont work on them. Thanks, Mike

Looks like I will call Flat-O-Matic this week. Thanks guys !!!! Mike

Ok guys I am tired of shifting,clutch chatter, I now have a 3 speed 1950 trans. I have a C-4 core that needs a rebuild, where do i get a adapter for a 1950 8ba? It has a stamped steel bellhousing, and is still 6 volt. The kits I find look like they fit the block that has part of a bellhousing on...

He lives in Tomball, Texas and uses his cell phone.

I bought me a fresh Holley 94 this week from Dicks Hot Rod Place. Fast service,great carb,price great,and best of all close to my town here in Texas. Check him out at WWW.dickshotrodplace.com 317-417-3202. Thanks, Mike

Thanks Guys !!!!! MG

Anyone try speedways C-4 kit for the flathead 1999.00 for whole kit? Tired of shifting !!!!! MG

Does anyone know the spec. on a 1949 or 1950 car wheel. I know they were 15, 5 0n 4.5, but dont how wide are and what the back spacing was. Thanks , Mike

Thanks that just what i needed. Mike

Does anyone know the alignment specs. for a 1950 ford car. I need to get the front end done but they dont know the specs. (caster,camber) Thanks, Mike

Sounds like you need to check the voltage while you are cranking your car, are take the battery to get load tested. Should drop to about 5 volts when it is cranking. I had this same thing happen and it was a bad Optima got a new one and it cranks like 12 volts. Mike

Any one know a good source for coil springs? I need a pair for a 1950 ford car.The last set i bought i think came from somewhere in the northeast,i just cant remember.Thanks Mike

I will get some fresh bulbs and check my grounds this week. I think it may be the grounds that need cleaning. Thanks guys and i will report back. Thanks Mike