Recent content by Deuce Coop

I have a 3W, B-Model # 158-651. Anyone have a production date? Also, have question if the B-model 3-W's had a trunk or a rumble. Mine came with a trunk, but this was made into a hotrod in the mid 50's. Don't shoot me, I brought it back to a full fendered car, (all steel) now. Contact me at...

I painted a rod flat black and used Emeron Industrial Paint. It was the same paint they use to paint dump truck boxes. Tougher then nails or the stones throw up by the dump trucks. You can't "oven" it. Must be air dried and takes about 3 days. Comes in 5 different grade of gloss. Mine was...

Trying to figure out which way the bottom door seal should be installed. There is a "flange" with the oval holes to go under the door panel. Then there is a lip and then the seal "flap". My question is, which way does the lip go, toward the interior or exterior. Any help will be really...

Hello: Mine was "*******-ized" into a hotrod in the late fifties, on the east coast area. The floor was cut out and channelled over the chassis 7", which was "east coast fashion" in the late 50's, early 60's. All the tags are gone, and the frame was most likely not the original. However, the...

Does anyone know where I can find a blank vehicle ID# tag for my 1932 3 window coupe. The old firewall has been "*******-ized" and the tags were gone. I have the "patents" tag, but need the tag for the ID#. In the past I have just had a trophy shop make one up. I would rather have something...

In case anyone needs to know, You can use Brookville Roadster's cowl panel for a Roadster, if you need to replace that same panel on a 3 Window Coupe. You will be trimming a lot of the new panel, but it works just fine. This will save you lots of $$$ between the roadster repair panel and the...

Thank you very much, that's what I really needed to know. Thank you. Coop

I mean the metal channel that the glass is set in and is fasten to the window operator. There is a [ shaped that the operator arms lock into. Which way should the [ go, open to the outside or inside. "Inside < ], or [ > outisde". I know where the "fuzzies" go. Always hard to use the correct...

Hello all: I am building a 1932 3 Window Coupe. It was a old late 50's east coast hot rod shell. Does anyone know which direction the metal door glass window channel goes. I have purchase new glass channels and they are marked and label as to which door they go in, but there is no indication...