Recent content by Bernie

My '39 ford is losing radiator fluid in the overflow when running. I have filled the radiator up to the top and when running it loses fluid through the overflow line. What'S up? Thanks for suggestions. Bernie

1939 Ford The bleeder screw has an end opening of about 1/8 inch diameter. Can I use a 1/8 inch plastic tubing or must I use a tube size that I can put over the end of the bolt? It is an original bolt. Thanks Bernie

Charlie, The brakes are relatively new ones and the problem developed slowly and is now very unsatisfactory. I drive the car only like once a month. When they were originally working they worked very well and that was probably six months ago. Thanks

Hi, My '39 fORD IS HAVING A FADING BRAKE PROBLEM. FEEL MUSHY WHEN I APPLY THE BRAKES AND REQUIRES A LOT OF PUMPING? WHAT TO DO?? THANKS, BERNIE

Temperatures in the storage garage 0 - 10F and choke helps some to get started. A little gas poured into carb also helps but not much. I have 10% ethanol blend -- does this make cold weather starting harder? Any suggestions ?

39 Ford cranks very well but no spark at plugs -- lights OK Where to look first for possible short??

Thanks again. I'm encouraged by your help! The photos of your installed headliner was super. Also, all of the good hints that comes from your hands-on experiences. Bernie

Thanks. I am still trying to decide to take on the job. I probably will go ahead with it since the car has the original fabric and it's falling to pieces. If I understand correctly I should first remove the entire headliner and then start putting in the new one. I can use my digital camera...

I'm wanting to install a headliner and have several questions. First, where can I get some detailed instructions? Second, can you tell me how difficult it is to put one in -- I've never seen this done and have heard that it's difficult. I have done a lot of work on this car, such a replacing...

Thanks, with the bottom cushion out I can see the straps that you mention. I will get the bolts going through the floor loose. I notice that they are almost solid rust but will start to work on them.

I'm having trouble getting the backseat cushion out of the car, 1939 Ford tudor. I would think that it simply lifts up and then out but it seems to be resisting???? Thanks

Thanks for the reply. I'm going to take your good advise and am anxious that I can get the bezel off without causing any damage. Bernie

Thanks for the idea. Bernie

Thanks for the tip about checking the rotation on the speedo. I've removed it from the car and will try to operate it by inserting a small wire . Bernie

Hi, My speedometer was acting erratic, jumping around and noisy, and suddenly there was a "pop." I had lubricated the speedo a couple years ago and it had been working fine. Anyhow, the speedo is dead in the water just now. I disconnected the cable and when I ran the car the cable wasn't...