Recent content by arc40s

  1. A

    Patten plate inside hood o fire wall

    is true" On the patten plate inside of hood on the fire wall the patten plate has a small square with two letters in upper right corner. these letters designate where car was factory assembled.
  2. A

    Tooth count

    Please clear question. what is correct 3:54 pinon / ring gear tooth count. 1941 ford banjo rear end 9 - 32 ? 11 - 39 ? 8-3/4" od thanks
  3. A

    ring & gear 3:25

    I still have a whine from old 3:54 gears (new bearings) rear end during decertation. think i will replace with 3:25 gear set. question is where to purchase. Where do suggest. Sacramento Vintage Ford Mac Auto Parts melvin classic for parts C& G parts Early Ford v8 sales or sugesstion others any...
  4. A

    brakes pull hard to right

    Replaced left / driver side flex hose cleaned left / driver wheel cylinder shoes clean ???
  5. A

    brakes pull hard to right

    Please offer any advise: 1940 Ford Tudor brakes pull hard to right replaced all wheel cyl. replaced flex hose driver side cleaned in side drums cleaned driver side wheel cyl new DOT 3/4 fluid drum not grooved riveted fabric lining ???? what next???
  6. A

    loud rear end 1941 sedan delivery

    Question: my 1941 Ford Sedan Delivery 3 speed on tree w/ 3:54 rear end has a loud whine while decelerating. no noise under acceleration or coasting with clutch depressed. how do I determined if noise from rear end or transmission?
  7. A

    front springs

    I have a 1941 Sedan Delivery wish to find out what are the dimensions between spring shackles loaded on vehicle and unloaded off vehicle what should be correct number of leaf springs in front & also rear spring
  8. A

    arc40s

    loud rear end
  9. A

    arc40s

    Question: my 1941 Ford Sedan Delivery 3 speed on tree w/ 3:54 rear end has a loud whine while decelerating. no noise under acceleration orcoasting with clutch depressed. how do I determined if noise from rear end or transmission?
  10. A

    flathead torque tube bearing

    I have a 1940 Tudor sedan that has a vibration around 45 mph. Tire balance is good So think it is torque tube bearing that is failing. Any one have a replacement and instructions as to how to remove and install Thanks
  11. A

    interior specs

    Please advise the interior specifications for a 1940 ford tudor sedan looking for arm rest angles front and rear. not sure if angle is measured from vertical or horizontal. Thanks
  12. A

    New Poll, What Year Fords Do We Own?

    I have a 1941 Ford Sedan Delivery
  13. A

    wirin for 49 3/4 to truck

    Where do you suggest finding a complete wire harness for a 1949 3/4 ton truck?
  14. A

    46th Annual Texas Tour

    We wish to extend a invitation to our up coming 46th Annual Texas Tour in Gonzales, TX April 11-14, 2019 “Be apart of the scene in 2019” This will be the 46thAnnual Texas Tour Sponsored by theHouston Early Ford V-8 Club” Region 50 April 11th– 14th 2019 in Gonzales, Texas Great Raffle...
  15. A

    rear gear ratio

    Please advise the teeth count for 1937-48 banjo 3:25 ratio thanks
See more
Back
Top