Recent content by aman538

I am putting an upholstery kit in myn 29 Murry 4dr sedan. I am having a problem mwith the window frames. There is a groove around the frames. Does the fabric covered cardboard go into this groove and if so how far. I did the drivers window but I am unable to get the screws along to bottom to...

I am in the process of upholstering my 29 murry 4dr sedan. I am having a problem with the window frames. There is a groove down the middle of the window frames. Does the upholstery covered cardboard fit into this groove & how far should it go in. I did the drivers door and have been unable to...

I took the drivers window out of my 29 Murry 4 door to replace it. I took the entire mech out and removed the regulator to clean and lube it. After replacing the regulator I noted the window would not fully roll down. The regulator was rolled all the way to the end, but the window was sticking...

I have never had a set of NAPA points fail me, and they last about twice as ling.

I believe these plugs were sold by western auto

I recemtly bought a jeweled cover for my daash l;ight in my 29 4 dr. I cant figuer out how to turn the light on with this thing installed. The normal thing was to push the cap in and twist till the light came on. What am I missing?? I have seen them on other cars so there must be a way. Thanks...

What is the best ething to put on the top of a 29 4dr sedan to protect and keep the top looking good?

Will try to get some decent photos

Original pop out ignition complete from key to distributor. Has key and works perfect. Taken off a 28 Model A. Has a few small cracks in the housing that do not affect the working. A hard to find switch in exellent working order.

This car is a one owner original Calif car. Car was parked in a barn in 1964 and was there untill I bought it. The car is very sound with only surface rust. There is one spot on the drivers side splash pan that has about 2" of rust thru. Fenders have never been split and are in excellent shape...

Is there any way to tell if a muffler is an aries. Is there any ID numbers or ways to ID it as an aries. Not sure if they made a steel muffler.

There is a model A swap meet comming up in Sacramento, also the one at the arco arena. Anyone have the dates for these two? Thanks

What causes a backfire after the engine has been shut off.

How important is it to have the distributor peg fully seated into the head? Mine lacks less than 1/8" to fully seat flat. I can see the grove for the holding screw thru the hole in the side of the block. Any help

Boat shops have used it for years with excellent results. If it is applied properly it is hardly a temp fix. I have used it on several projects and am very satisfied. Never used it on styrofoam. Try it on a small piece. Only problem is you don't have much time to work with it, so don't mix to...