Recent content by admiral1960

Solid state vibrators, + or - ground are available. I would go modern here, they do not show.

WTB metal bars/straps for 1935 Locking hubcap for my FORDOR DELUXE Sedan.

WTB 1935 Dash Light Switch to replace the one I have. It shorts out occasionally and blows "the" fuse.

Hi, Is there a market for the Early Ford Club V8 magazines? I have a collection going back to 1973. Most years I have all six magazines.

Need 1935 dash light switch

Have a transmission with serial number "9C I 508" followed by a star. Could someone tell me what year this was manufacured. Thank you !!

thanks for the info guys !!

Hi everyone, Another project: Removal & replacement of front & rear springs as they squeak going down the road. Am considering removing them and installing the Spring Liner that comes in 20' rolls. Is that fairly easy to do ? If easy what are the basic disassebly steps ? If I...

Hi, Does the compressor you show compress the spring from the top down or the bottom up ? The engine I have is a 48 (I think) and the keepers are at the top. Thank you for a reply

Thanks for the input guys !!!

Is there a tool for compressing valve springs so that the keeper can be removed ? I know there is a bar like tool that compresses the spring but difficult to do one handed and remove the keeper with the other. Is there a tool that compresses the spring and locks in place so that you can...

The engine block I have has 2106910 followed by a star stamped on the top rear, driver's side. The intake manifold would cover the numbers. Seems to me I have seen mention of this being done sometimes to engines that were reuilt. The numbers being those of the car the engine was going into...

I have a 46-48 flathead. Pistons are frozen but not badly and probably not all of them. Have been sprayining a penetrant into cyliders occasionally for a few months. Suggestions please as to how to proceed freeing pistons. Have thought about giving the top of each piston a few whacks...

Thanks all for the information. If I were closer to Spokane I would take you up on it. Thanks again

thank you for info