Recent content by 35window

Thanks!

Thank you both for the quick replies! JM 35 Sedan, I appreciate your willingness to help, and I just may take you up on that if something doesn't turn up- JSeery, thank you, and I will go there and take a look to see if there's something there I can glean from-I was wondering why the darn thing...

Thank you for you thoughts and pictures!! It's hard to tell from the Photos, but are the strips flat? Or angle? I don't know where to get them (I can't find where anyone has sold them, and don't know of any Cars near me that do), but I wonder if I could just make them? They appear to be made of...

Good afternoon everyone, I am in the final stages of my '35 build, and I purchased a Header Panel off of ebay to fit it-after getting it metal finished to my liking, I tried to fit it, only to realize that I was definitely doing something wrong-:( So, I came here and found an excellent thread...

Thank you very much for your help Gary-as simple as it is, it's confusing to this old guy-I appreciate your help (a lot!)-

If you are willing to make the investment, Stainless lines can be relatively easy- Buy annealed Stainless line, and either buy the Eastwood Flaring Tool or the Mastercool unit: http://www.mastercool.com/product/71475/ I have the Mastercool unit, and it works very, very well- Buy a good Bender...

Thank you very much for your input-so, on the '36 that you did, the Fuzzy's took care of the possibility of rattling then? (Sorry, I'm a little slow :) )- You know, I wasn't aware (and hadn't looked) at my rear Window Moulding (it is a roll up)-that is some great information!

Good Morning! In my quest to build my '35 Coupe, I had to purchase Garnish Moldings as it did not come with them-as they can be hard to find, I ended buying them from different sources, and, while refinishing them I noticed that some have small rectangular holes in them, and some do not- After...

Do you, by chance, have a Bead Roller? With a tipping wheel on a Bead roller you could easily create the Panels you posted-otherwise, I would make them with a wooden buck-

Frank has given some great advise here, and I'll add my two cents-sounds like you are going to have some Dents to deal with. I'm not sure how anal you are willing to go with your Dents-some guys are ok with getting it close and using Bondo, others want to Metalfinish (or close to it). If you...

I purchased a set of your Running Boards recently, and I am very happy with the quality-thanks

Thanks Mike, I have been looking for that Page!

Karl, Thank you! I just called and ordered themn from your Company, and I thank you for the help! JM, Thanks so much for the pictures-I have copied them and will refer to them. Thank you for taking the time and effort to show them to me! What a great resource this Forum is, and I hope...

Isn't it great that there are so many different ways to Paint a Car that will ultimately satisfy the end-user? And, there are many ways to disagree respectfully on the Internet. I will absolutely believe in SPI and Barry Kives, they haven't steered me wrong yet-you might consider trying some of...

Thank you Bob Drake for making the parts I need to complete my project-