Zenith 2 tip

[holdover]

Rebuilding a few carbs and I came across the odd size 13/32 for the GAV assembly. removed it with a adjustable wrench, but wanted something better. Snap-on and others made a special wrench for this available on ebay etc., but it is about the only use you would have for it. Took some measurements and found that it is only a few flat file strokes away from being a 10MM. Problem fixed no extra expense. Maybe not for the purists, but works for me...

 

[Bob C]

There was a member who made a run of 13/32 sockets for us a few years ago.
https://www.fordbarn.com/forum/showthread.php?t=160740


Bob

 

[taffrail]

Some of the crap off shore wrenches are so bad they fit right out of the cheep plastic holder.

 

[jhowes]

What happened to the (Haag 1332) wrench? Did he decided to make a few or a large run or none? Do any of you guys know? Jack

 

[Ed in Maine]

I picked up an 11 mm. deep socket at Home Depot and it seems like it will do the job. Ed

 

[KGBnut]

I grab this one off Amazon. It was a little pricey, but it works well.

Martin 5/16" x 13/32" Wrench

Ken