Wire looms

Check with Flathead Jack on his website. I found that many times he has things that the other FH parts suppliers do not carry. However, he does seem to charge somewhat of a premium for his parts, but hey, if he carries things you can't find elsewhere that you really want/need, I would buy from him.
 
37don said:
Does any one have a source for 8mm wire looms? All I have seen are 7mm.
Thanks, Don
Click to expand...
I couldn't find any, either, so I made my own. I can send you all the measurements and stuff if you'd like.
 

Attachments

  • Looms.jpg
    Looms.jpg
    492 KB · Views: 94
That would be great if you don't mind Richard. It appears that you have them under rather than over which I prefer. Your engine is beautiful by the way.
Thanks, Don
 
Wire looms look cool but they will cut the spark plug current somewhat due to capacitive leakage.
 
37don said:
That would be great if you don't mind Richard. It appears that you have them under rather than over which I prefer. Your engine is beautiful by the way.
Thanks, Don
Click to expand...
Give me an e-mail address, either here or in a PM.

Thanks for the nice words on the engine. An enormous amount of planning and execution went into it.
 
Don , i made a set of wire loom like Richard. I used aluminum tubing and buffedit on a buffing wheel. it came out looking like chrome. I got the tubing from McMaster-Carr.com and the aluminum seperators from performance distributors .com
Don't know if it will help , just passing it along
steve
 
Thanks Choiceph, I got a material list and good diagrams from Richard in Florida and will try to make my own as you did.
Regards, Don
 
You must log in or register to reply here.
Back
Top