Windshield Wiper Motor Installation HELP

R

REByar

Member
Hi All
I have a August 28 Tudor with a new windshield. I just purchased a rebuilt Owen-Dyneto wiper motor. Because my windshield is new it does not have any holes. Can anybody provide measurements on exactly where I should drill the holes in the top of the windshield frame? It appears there would be two holes for the mounting bolts (one on either side)and then one for the switch lever and one for the hand operating lever. Is that right?

Any help would be greatly appreciated.

Randy
 
Marco posted this picture.

Bob
 

Attachments

  • closed_frame-01.jpg
    closed_frame-01.jpg
    63.3 KB · Views: 54
If you have the correct wiper motor for your car: an OD-C1B with the offset wiper shaft, then Marco diagram doesn"t apply.
 
You must log in or register to reply here.
Back
Top