Whitch one do I use ??

G

GT66PONY

Member
I have a roll of after market frame welting that is 2 inches wide and made of nylon. and I have a roll of belting that is 1.5 inches wide Made of reinforced rubber! Both are about the same thickness.
Which would be better to use?
 

Attachments

  • IMG_1077.JPG
    IMG_1077.JPG
    195.3 KB · Views: 36
this is the proper size and material available which mimics what was originally used closer than rubber or a wider width nylon. and it costs 16.50 to do the whole frame
 

Attachments

  • image.jpg
    image.jpg
    55.2 KB · Views: 69
Last edited:
I use what mitch posted on the 30 AA I did years ago. I found you should cut the roll in half and tape each half to the frame rails, then let it set for a day or two to normalize, then mark and punch the holes. I unrolled the welt and taped and punched the holes in an hour, but when I went to bolt parts on a couple days later I found the stuff had to be pulled hard to get the holes lined up again. It shrunk a bit.
 
Tom Wesenberg said:
I use what mitch posted on the 30 AA I did years ago. I found you should cut the roll in half and tape each half to the frame rails, then let it set for a day or two to normalize, then mark and punch the holes. I unrolled the welt and taped and punched the holes in an hour, but when I went to bolt parts on a couple days later I found the stuff had to be pulled hard to get the holes lined up again. It shrunk a bit.
Click to expand...

The respected voice of experience once again offers his great advice ! This man speaks with experience to back it up.
Wayne
 
You must log in or register to reply here.
Back
Top