When replacing a condenser, where does the insulating washer go?

The washer installs on the tab of the lower plate. The easiest way to install it is to glue it to the tab before you install the lower plate.

Tom Endy
 

Attachments

  • Insul washer-re.jpg
    Insul washer-re.jpg
    90.4 KB · Views: 183
Thank you for the rapid reply. Does it go on the screw side of the tab or the condenser side of the tab? It looks like, in your picture, to be on the screw side.
 
Is it possible to hold the screw/washer in place while replacing the condenser, or does the distributor need to be disassembled in order to replace the condenser?
 
Last edited:
oldbike99 said:
Is it possible to hold the screw/washer in place while replacing the condenser, or does the distributor need to be disassembled in order to replace the condenser?
Click to expand...

Changing the condenser is a very easy one minute job IF you follow these steps:

Lay the new condenser next to the distributor and unscrew the ground screw FIRST.

Walk to the driver's side and unscrew the terminal screw and keep holding light pressure on the screw.

Slip out the old condenser and slip in the new condenser and turn in the terminal screw.

Walk to the passenger side and turn in the ground screw. JOB DONE:)

Forgot to mention........if you have 6 helpers, the job could take an hour.:D
 
Last edited:
Do not be tempted leave this washer out. The copper screw will bottom out before making a tight connection. If you try and force it you will ruin the condenser.
 
Now that all this is done, is there a plastic or rubber plug that should go in the hole after all is said and done? I know originally there was some sort of sealing wax in there that got destroyed the first time this got changed out 150 years ago.
 
You must log in or register to reply here.
Back
Top