Water return housing

Dougs 28

Dougs 28

Member
Putting a new Bergs radiator in and took the inlet housing off to Change the gasket along with new hoses and went to put the housing back on, using the same bolts that came out, and they won’t tighten, nothing seems to be stripped but the threads in the block seem to be worn down/out. Just wondering what’s the best way to solve this problem. Thanks in advance.

Doug
 
The threads in the block are most likely stripped. You will need to find some type of thread repair. I always caution people not to disturb fasteners if not necessary. The model A should use studs & nuts and not bolts.
 
If you don't have acess to any thread repair methods another possibility is using the few threads left in the bottom of the hole, get a long bolt, or all thread and screw it all the way to the bottom then use a nut
 
You must log in or register to reply here.
Back
Top