valves

did compression check on my 239, 59a everything seems ok coming out at 125 psi.but car will not start or idle, carb and fuel pump check out, poured gas down carb and backfire and smoke, timing or valves,give me your suggestions , condenser, coil, ran fine month ago ,sat then this ?? carb rebuilt last year, newer fuel pump. Help
 
Not valves, 125 PSI on all cylinders means the valves are moving and seating.
Diagnose the problem, fuel or spark. Verify spark before looking at fuel. Do you have a hot blue spark at the plugs?
 
Especially if it's a current replacement. They have proven to be inferior. If you need to replace it, strongly consider an aluminum gear.


Would you still get good compression readings it the timing gear broke some teeth?



- Check for a blue spark that will jump half an inch when cranking. If good, go back to the carb and fuel system. If not, Check:
- Coil wire fully inserted into coil and distributor. Primary connections and wires good.

- Check battery voltage at coil with points open; drop a couple volts with points closed. Nudge the engine rotation by crank pulley or shoving the car a bit in high gear.

- If all that looks good, pull the distributor, clean and adjust the points precisely. And replace the condenser.
 
Back
Top