Vacuum wiper ,fuel pump Questions

I can't find a decent photo. If you have a combination pump. the pump itself is on the PS of the engine and the intake manifold on the DS of the engine. The plumbing is complicated.

If no one here comes up with a photo, I will go down to my 'COBWEB CORNER' and look through the 1955 WSM.
 
On hooking up the fuel pump vacuum lines if I go from the line to the intake and the other to the wiper it should work?
 
elmo771 said:
On hooking up the fuel pump vacuum lines if I go from the line to the intake and the other to the wiper it should work?
Click to expand...

Basically yes. The vacuum pump needs a manifold vacuum signal to operate. The other line will go to the wiper motor.

I was trying to find a good photo but cannot. I still need to check the WSM to see if there is a good install ILL ...

The will be four steel lines -

FUEL LINE -

MANIFOLD VACUUM SOURCE LINE -

VACUUM MOTOR LINE TO MOTOR -

LOAD-O-MATIC LINE FROM CAR TO DIST -

See if these photos show large enough -

ADDENDUM -

Well, I have some old photos of the system but for some reason this system will not upload them.
 

Attachments

  • Wiper Motor - Vacuum Source _1 - Fuel-Vacuum Pump Comb.jpg
    Wiper Motor - Vacuum Source _1 - Fuel-Vacuum Pump Comb.jpg
    60.6 KB · Views: 6
Last edited:
elmo771 said:
Thanks for the pictures. It all makes sense now
Click to expand...

I was hoping to do better. The MPC doesn't show a detailed engineering drawing of the install(s). I haven't opened the WSM yet but also doubt it goes into detail.

It is the same design just split because FORD put the components on differing sides of the engine for the I-223 SERIES,
 
You must log in or register to reply here.
Back
Top