Un welded exhaust pipe and muffler

maako

maako

Member
Need a new exhaust pipe and muffler anyone make one that is not welded together? Over size shipping to Japan is expensive.
 
I had one sent to Australia by Sammy Guthrie at Arizona Model A. I asked him to put a piece of masking tape around the pipe just behind the muffler and put a longitudinal pen line on it, then cut the pipe off through the tape. When it arrived, I could line things up again to weld it back together. It worked a treat. I see no reason the same couldn't be done with the engine pipe and have it shipped in 3 pieces. (I'll give you Sammy's email contact if you like - just PM me)
 
When I talked to Aires a while back, they would send theirs in pieces. I ordered mine that way.
 
I just need to comment. That's good service. Thank you amuffler. Keep up the good work.
You really have the best interest of your customers in mind. Jeff
 
Boston Bruce:
I have a woody. I bought an Aires stainless steel muffler maybe two years ago. You cannot get it on the frame without either raising the body or preferably lowering the entire rear end to allow it to be installed. You will also need the extension pipe that Aires also sells for the woodies. The extension is not stainless steel so you will need to cut and fit the two pieces together.

Vic
 
You must log in or register to reply here.
Back
Top