U Joint

B

bosticjb

Member
Picked up a good used U JOINT AT SNYDERS TODAY MY QUESION IS SHOULD I Pack it with greese or just greese it with greese gun after everything is put back together
 
I just finished putting my spare motor/trans in my car and I packed the u-joint/clam shell the best I could before bolting it together, then I used the grease gun to complete the job.
When the grease started coming out the speedo gear housing on the drive shaft tube I was happy. I'm not sure if that is the correct way but I know my u-joint is packed full of grease. I used JD Corn Head Grease
 
PalAl said:
I just finished putting my spare motor/trans in my car and I packed the u-joint/clam shell the best I could before bolting it together, then I used the grease gun to complete the job.
When the grease started coming out the speedo gear housing on the drive shaft tube I was happy. I'm not sure if that is the correct way but I know my u-joint is packed full of grease. I used JD Corn Head Grease
Click to expand...

This is the way I would recommend doing it.

Enjoy.
 
Might change out the grease fitting with a modern Zerk type to simplify pumping in grease with a gun. The fitting just threads in and is an easy change.
 
You must log in or register to reply here.
Back
Top