Transmission dipstick kit

I put one on my coupe. Purchased from Mitchel OD/trans mfg. I’m 82 and limit my time under the A if possible. Cut a hole in the floor board and pull the carpet back to access the dip stick. YEA, no more back pain! 👍 😊
 
The transmission dip stick makes the level easy to check, but not so easy to correct. I had to try several funnels to get the right shape/size to use to fit through the floor board and to fill through the tube; and then you have to add a little at a time and recheck with the dip stick several times to know if you have added enough or too much. You have to replace the cap each time in order to use the dip stick and get a correct reading.

But it is still easier than crawling/squeezing under the car in the dirt, and lying on your back with oil dripping down you wrists and into your face.

W. Michael
 
I have one, use for same reasons as post 5, back issues.


I also installed the Battery access kit so I do not have to remove the entire lower floor board to remove/install/service the battery.
Type in Macs parts, search for battery kit. Tried to include a link, but keeps going to a Ecklers Corvette parts page.
 
Last edited:
Only downside, would be nice if they made a trans kit where the tube/dip stick stuck above the floor. Then there would be no need to pull the floor covering and access plate up.
 
My solution to ease access to the transmission fill plug.
 

Attachments

  • 190A Front Floor Boards w Trans Access Mod 348kb.jpg
    190A Front Floor Boards w Trans Access Mod 348kb.jpg
    70.5 KB · Views: 117
  • 190A Front Floor Board w Trans Access Mod 331kb.jpg
    190A Front Floor Board w Trans Access Mod 331kb.jpg
    77 KB · Views: 90
  • 190A Floor Board Heat reflector 347kb.jpg
    190A Floor Board Heat reflector 347kb.jpg
    32.1 KB · Views: 86
Hi Fred, yes I have it since 9 month. It is a good idea. I would buy it again.
 

Attachments

  • P1090705.jpg
    P1090705.jpg
    98 KB · Views: 67
Back
Top