Stromberg 97 jet question

S

swedishsteel

Senior Member
Discovered one jet was a thread or two from seating. How would that, if at all, affect how the motor would run? Would it run lean on low vacuum situations? Thanks for any ideas. Rod
 
If it was just backed off a thread or two, it's probably not enough to block off the supply of fuel from the bowl. It might leak a little fuel around the threads when there is suction from the emulsion tubes, but chances are you may not even notice any thing wrong with the performance.
Also, the jets hold the emulsion tubes in place (seat on them), so possible the tube came down as far as the loose jet was.


Sal
 
You must log in or register to reply here.
Back
Top