steering worm gear

[bnchief]

Looking at the worm gear on my 30 tudor to replace i assume it will go on either way or is it directional?

 

[SwansEarlyFord]

Yes it is.

 

[bnchief]

After i got the old one off my question is answered that new one is a real pita to pu back on

 

[Terry NJ]

You guessed it! The new one has to be fitted. I wound up filing it down a little and tapping the the shaft a putting a piece of ready rod in the threaded rod and screwing a nut and large washer to pull it down into place. This was four days after I started the job with a large lead hammer and a propane torch. BIG PITA!
Terry

After i got the old one off my question is answered that new one is a real pita to pu back on

 

[Mitch//pa]

In case you have not seen this
http://fordbarn.com/forum/showthread.php?t=108627&highlight=Worm

 

[tbirdtbird]

...

 

[midgetracer]

I've used that method 3 times and had great sucess. Quick and easy. I once bent a shaft trying to drive one on with a brass sledge.

 

[bnchief]

Mitch your method is what i am using but this new gear is really galling the shaft bad i know it should be tight but not this tight and yes i did line up the key part of the gear on the shaft and got it started real good also it is the last inch that does not want to go.