Squealing niose - RPM dependent

FordTudor1931

FordTudor1931

Member
My 31 Tudor engine had a squealing noise that I could not locate. The plan was to attack each point in order and check possible success.
1. Oil distributor shaft
2. Oil engine front mount
3. Spray water on fan belt
4. Remove fan belt to exclude water pump and alternator as the source.
5. Scratch head (mine!)
6. Sign on to Ford Barn for new ideas.

#1 solved the problem and no additional action was needed. It is great when an easy fix shows up!!
 
Welcome. I just took apart a distributor that someone had installed a simple spring loaded flip lid oiler, which of course means you'd be squirting oil in from the side. This will not hold oil and will not properly lubricate the distributor shaft. I have an original oiler for the distributor and will install it when I restore the distributor.

That oiler should be filled to overflowing every 500 miles. You can not over lubricate the distributor.
 
Tom Wesenberg said:
Welcome. I just took apart a distributor that someone had installed a simple spring loaded flip lid oiler, which of course means you'd be squirting oil in from the side. This will not hold oil and will not properly lubricate the distributor shaft. I have an original oiler for the distributor and will install it when I restore the distributor.

That oiler should be filled to overflowing every 500 miles. You can not over lubricate the distributor.
Click to expand...


Thanks Tom, my distributor has the oiler you mention and I have to continually oil it. Didn't realise it wasn't origional. Is this it? So you fill it up and screw it on ?
A12135.jpg
 
Last edited:
FordTudor1931 said:
My 31 Tudor engine had a squealing noise that I could not locate. The plan was to attack each point in order and check possible success.
1. Oil distributor shaft
2. Oil engine front mount
3. Spray water on fan belt
4. Remove fan belt to exclude water pump and alternator as the source.
5. Scratch head (mine!)
6. Sign on to Ford Barn for new ideas.

#1 solved the problem and no additional action was needed. It is great when an easy fix shows up!!
Click to expand...

Wecome to the Barn!! So now your the noise expert we all can go to :-)
 
Manager said:
Thanks Tom, my distributor has the oiler you mention and I have to continually oil it. Didn't realise it wasn't origional. Is this it? So you fill it up and screw it on ?
A12135.jpg
Click to expand...

The wrong one I spoke about is the type with the flip lid, as found on most small electric motors.

The one you pictured is the sliding sleeve type, so you have to pull back on the knurled sleeve and squirt oil into the hole until it's full. When you install this oiler into the distributor, be sure you slide back the sleeve and note the position of the oil hole, so you have it UP when the part is tapped in.

The reason the remove these during restoration is to make painting and blasting easier, and to clean out any old dirt and dried hard oil.
 
Yeah mine at present has the flip lid type. Is the sliding sleeve type origional style or is origional something different again?
 
Get rid of the flip lid type and install the original style sliding sleeve oiler.

The flip lid will not oil the shaft correctly.
 
Last edited:
Newbie question....do I just use regular motor oil for the distributor or is it something else?

Thanks

Nick
 
If the flip lid type has a 90* bend so it holds the tube full of oil, it will be fine, but if it's the common small push in style so you have to squirt the oil in from the side, it just won't hold the oil. Your choice, your gamble, but I'll stick with Ford's original that works and has for 85 years.
 
You must log in or register to reply here.
Back
Top