Spark Plugs

M

metro1

Senior Member
I thought I read somewhere that a 292 with points and a resistor should use non resistor plugs. Seems the recommended plug for this engine is Autolite 46 which is listed as a resistor plug. What about wires? Resistor or not. I've read quite a few discussions about plugs but have not seen this mentioned.
 
Copper plugs will offer the best performance but not longevity. If you have a radio/or install pointless ignition in the future, you'll want resistor-type plugs and wires. Autolite 46 is the standard plug for Y-blocks. If your engine has been modified or runs on the hot side, try Autolite 45s. NGK 2438 plugs are recommended as a substitute for Autolite 45.

I wanted the Autolite 45 for my 55 Tbird. Walmart raised the price, so I bought NGK 2438 from RockAuto. Later, I was looking through my garage cabinets for parts and found a box of Autolites.
 
Thanks for your reply. I had the AM radio repaired and am going to reinstall. For now I plan to keep the points and standard coil. I guess I need to get some resistor wires also.
 
metro1 said:
I guess I need to get some resistor wires also.
Click to expand...

Resistor and Suppression type plugs introduction began with the 1968 model run.

If a FYB 292, the wires are unique as they are held in place by brackets/insulators that will only accept a 7mm wire. You can buy them pre-assembled (for easier install) or A 7mm wire (with 8mm core) kit from PERTRONIX (good quality).

If you want a non-resistor plug, search for NOS (New Old Stock) BF-82 (FYB heat range) AUTOLITE (FORD) or later MOTORCRAFT.
 
Last edited:
You must log in or register to reply here.
Back
Top