Slant Windshield Dimensions (Model 190A)

D

djuby1

Junior Member
I need the dimensions of a slant windshield frame for a early 1931 Model 190A Victoria that I am restoring. I have a original frame that I think is the correct one, but need the dimensions to be sure. Does anybody know what these are. I have not been able to locate this on the internet anywhere. Any help would be appreciated.

Cheers,
 
Last edited:
The dimensions of the Victoria 190A frame are the same as any other Model A frame used during 1930-31. However, there is a special body mount bracket for the slant windshield bodies, including the Victoria, that was introduced in the later part of 1930. What specifically are you looking for? Post a photo of your existing frame and it can be determined if it has the extra body bracket. You are invited to join the Victoria Association, they have all the information particular to that body style.
Vern Schwebke, President
International Model A Victoria Association
Vern190A@cox.net
www.VictoriaAssociation.com
 
Since you have " windshield frame" underlined I figure that's the dimensions you want. I measured two with the sides/ends at 14 5/8 to 14 3/4" affected by the hinge condition. The bottom is 44 1/2" and the top is 45 1/2". As an aside the straight windshield frame is 16+" on the sides/end.
 
Vern,
Thank you for getting back with me on this. I can send you a picture of the frame. I bought it from Bratton Part number 30080 which has the hinge attached to it. I do not see the special body mount bracket that you reference to anywhere in the Bratton parts catalog. Can you inform me where I can find this bracket. I believe this bracket is missing because we can not get the windshield to seat properly in the window opening. Again thank you for any help you can provide.

cheers,
 
djuby1 said:
Vern,
Thank you for getting back with me on this. I can send you a picture of the frame. I bought it from Bratton Part number 30080 which has the hinge attached to it. I do not see the special body mount bracket that you reference to anywhere in the Bratton parts catalog. Can you inform me where I can find this bracket. I believe this bracket is missing because we can not get the windshield to seat properly in the window opening. Again thank you for any help you can provide.

cheers,
Click to expand...
Because your wording could be confusing, I'm guessing Vern thought you meant the "chassis" frame which has the additional bracket on the sides for mounting slant window bodies. Nothing to do with the windshield frame. Therefore you have some other issue with the windshield.
 
djuby1, boy did I miss the question! :o
Roger & Mike, as usual, provide the proper answers....There is NO special body mount tab on the windshield frame! But I still invite you to join the Victoria Association, where we know a lot, but obviously not all, about Victorias.
 
It is quite simple.

The straight window frame is too large to fit in the hole as the slant window frame is about 2" shorter if I remember correct.

Also the real big clue, no hole in the top part for a windshield wiper. The 190A and the 160A/B/C have the wiper hole in the header. If your frame does not have a hole and has the metal for holding the rubber seal then it is correct. I think the later pickups had a frame with no hole and no metal for holding the rubber seal, I have one laying around.

The 400A and 68C will have a special bracket and the wiper goes though the top part.
 
You must log in or register to reply here.
Back
Top