Shut off valve filter

L

Lenny Bruce

Senior Member
Good morning. I developed a backfire in our coupe again. Lack of power and loud cracks out the exhaust. Brought it home and put compressed air through the gas line and once again temporarily fixed the issue. I’m going to replace the
Pencil filter in the shut off valve. Is their a supplier that sells a particular one that works best or are they all the same? Thank you
 
I have always had good luck with the sediment bowl. If the fuel flow is low enough the crap settles out. If needed a filter can be added that is easy to change. I have always used the glass ones. Not sure what your car has but you may want to consider the glass sediment bowl.

Clarification: I was suggesting the sediment bowl instead of the filter in the bottom of the tank.
 
Last edited:
I have the glass sediment bowl with wix filter. It’s the gas valve under the dash. That filter I’m assuming needs to be replaced
 
Hi, Snyders sells a "Fuel Shut Off Valve" with a "A-9193 Screen"; $34.00. I have both in the last year and they work as advertised-"Wont Leak!". Definitely a major upgrade as I went thru 2 different valves in the previous 7 years.
 
Hi again, I should have mentioned that the A-9193 TX screen has to be separately purchased with the valve; cost is $5.60.
 
gary678* said:
Hi, Snyders sells a "Fuel Shut Off Valve" with a "A-9193 Screen"; $34.00. I have both in the last year and they work as advertised-"Wont Leak!". Definitely a major upgrade as I went thru 2 different valves in the previous 7 years.
Click to expand...

Yes, Snyder's new ball valve is great. Unfortunately the A-9193-TX pencil filter is "Out of Stock" currently.
 
It appears you have a lot of loose sediment, rust, or whatever in your tank. Maybe you should park on an incline and at minimum drain it and flush it a couple of times before installing filters.
 
Maybe you need a "dirty leg":
 

Attachments

  • Dirty Leg.jpg
    Dirty Leg.jpg
    37.4 KB · Views: 55
I buy 6 pencil filters at a time and always have them on hand for the "next A"


I also use the bowl on the firewall with a magnet in the bottom. Everything seems to work pretty well.


This is after a major flush upon purchase of a "new" car.
 
I will try and clean the tank. It seems decent but who knows what settles down their. My shut off valve works fine. Is it ok to just change the filter?
 
Lenny Bruce said:
I will try and clean the tank. It seems decent but who knows what settles down their. My shut off valve works fine. Is it ok to just change the filter?
Click to expand...
yes or if you clean the tank reinstall the existing pencil filter that you have.
 
When I purchased my ball valve from Snyder's last year they were also out of the pencil filter then I used my older style round pencil filter and a little bit of JB weld on the new valve and everything worked fine!!!
 
The tank in my Victoria was thoroughly cleaned before installing it during the car's restoration. However, fine sediment continues to be trapped in the bowl. I have a pencil screen in the gas shutoff valve and the glass bowl is completely stock. My expectation is that there will always be some sediment in the gasoline.
 

Attachments

  • 190A Glass Sediment Filter w Debris 280kb.jpg
    190A Glass Sediment Filter w Debris 280kb.jpg
    26.6 KB · Views: 13
You must log in or register to reply here.
Back
Top