Seat belts install. instructions for 40 conv

W

warren va

Senior Member
What is the procedure for installing front and back belts. Some pictures and or drawings would be appreciated.

Thanks

Warren
 
Slip the anchor ends between the seat and its back. Roll back the rear mat and choose a place that will allow the belt to extend straight down to the floor pan. Drill holes in the pan for the bolts. Don't mount the belts to the frame because in a crash, the body may separate from the frame causing the belts to become tight enough to cause injury. Place a large "fender washer" under the floor pan and over the bolt, and tighten firmly. Belts are always a good idea, and imperative in open cars. Buy the best belts you can find. That is no place to pinch pennies.
 
Thanks for the replies.
Paul;
Would you use the 6x6 plate on top also or just the bottom side with flat washer on top ?Are we talking about floppy or non retractile belts, and if the latter, should there be two separate anchor bolts for each set of belt? How far apart should the anchors be for each set? Anyone have any pictures or drawings of an installation?

Thanks
Warren
 
Last edited:
When I installed belts in my 32 in 61 I just put the plate under the floor, on top a large washer then the belt assy, about the distance apart that I was wide.
Paul
 
I can not comment on the procedure in this specific install, nor do I have pictures.

The bigger the plate to the floorboard the better. It helps to insure that it doesn't pull through the floor. The floor is around 18 gauge. The larger the area of the plate, the better it will hold. Not very scientific but practical thinking. Surface tension.

3 point if your able, would be suggested by me. Laps for cosmetic reasons okay. Something is better then nothing. But your asking so you already know that. Commend you on your idea to do so.



..
 
Last edited:
warren va: You asked for opinions about retractable vs. non-retractable. Retractable's are best for keeping the belts out of the way but if you have a coupe or tudor inspect the style of the belt to be sure which ever style belt will not hinder people entering or leaving the back-seat area (not a concern with a 4-door). Incidentally, and based on my experience with my '47 sedan coupe, if you use three-point belts for the front seat you may install the pillar anchor of the belt by removing the interior rear window frame and peeling-back the fabric upholstery on the pillar. I attached mine just below the pillar light fixtures and handles.
 
Thanks all for your help.
Julianos really has a great selection of seat belts and installation hardware on their website.
Since I have a rag top, will likely have to go with lap belts. I see Julianos sells a clip on type retractable roller to keep the outer long belt from falling in the floor when not in use.Hate to drill all those holes in the rear floor and carpet,but the safety feature will be worth it.

Thanks again;

Warren
 
You must log in or register to reply here.
Back
Top