Scuff plates

B

bill h

Senior Member
Has anybody run in to fit problems with the metal scuff plates in a 1940 ford coupe from carpenter.
 
bill h said:
Has anybody run in to fit problems with the metal scuff plates in a 1940 ford coupe from carpenter.
Click to expand...

Nope, not a once. The rubber is too long, which is a good thing in my opinion. Being too long, they can be trimmed perfectly to fit.
 
Will this help? This is on a 40 coupe. The floor pan bolt with washer shown in Photo 6 is not OEM. Board covers and scuff plates are from DRAKE many years ago. Carpenters are probably the same.
 

Attachments

  • DSC04866 (Small).JPG
    DSC04866 (Small).JPG
    44.2 KB · Views: 49
  • DSC04867 (Small).JPG
    DSC04867 (Small).JPG
    61.5 KB · Views: 57
  • DSC04869 (Small).JPG
    DSC04869 (Small).JPG
    47.4 KB · Views: 55
  • DSC04871 (Small).JPG
    DSC04871 (Small).JPG
    45.5 KB · Views: 51
  • DSC04870 (Small).JPG
    DSC04870 (Small).JPG
    47.7 KB · Views: 48
  • DSC04872 (Small).JPG
    DSC04872 (Small).JPG
    59.9 KB · Views: 50
  • DSC04873 (Small).JPG
    DSC04873 (Small).JPG
    23.4 KB · Views: 31
Last edited:
bill h said:
Thanks
Click to expand...

Bill,
One thing I do as soon as they arrive is to bind the rubber over and let them sit for a few weeks. That way, the rubber seal will obtain a memory of where it should sit.
Makes the eventual installation so much easier.
 
You must log in or register to reply here.
Back
Top