Revive 32' Steering Wheel

Ian1932

Ian1932

Senior Member
So i have 7 steering wheels for a 32'. They all have little cracks in the front except one. They are have little cracks in their backs. I took one that is the best. Not sure what this material is...??? How can i "re-furbish" this wheel? It almost seems like you could sand it with 2500 and water and then maybe clear coat in or paint it? Maybe i could fill the cracks with epoxy or bondo? Anyone have any experience doing something like this? Any tips would be appreciated! Thanks!
 
Ian,
If the cranks aren't bad I use polyester filler.. If they are bad I use PC7.. Also note 32 wheels the outer reveal ribs are always worn off.. Are yours? Out of seven I would imagine you could salvage hopefully at least one, and use a rougher one to practice on.
A new perfect reproduction of the 1932 Ford steering wheel will be on the market soon. I have to let DavidG check out the sample of it first ;)
 
Last edited:
35fordtn said:
Ian,
If the cranks aren't bad I use polyester filler.. If they are bad I use PC7.. Also note 32 wheels the outer reveal ribs are always worn off.. Are yours?
A new perfect reproduction of the 1932 Ford steering wheel will be on the market soon. I have to let DavidG check out the sample of it first ;)
Click to expand...

It didnt look that bad...However i dont have a new one to compare it to..
 
I don't want to post a photo of the new one on here yet, but If I remember tonight I can photo one of the wheels in one of my 32's at home.
 
Here is a photo of a steering wheel in a 1932 restored by DavidG on here (hope David doesn't mind). I won’t be home to photo mine till late tonight and I happened to have this photo on my phone. I was a wee bit obsessed with the wheel on this car, as it's the most beautiful 1932 Wheel I have ever seen!

1b62ea41cc9558d42b4fc81aef19bc99.jpg



Sent from my iPhone using Tapatalk
 
Use the recommended PC-7. I restored my 32 wheel twenty plus years ago and tried using
bondo the first time around. It ended up cracking on me so ground out the bondo and used PC-7. It still looks as good as the day I refinished it. At the time I used Black Centari urethane and added a flattening agent to dull it down. I ground all the cracks sealed the
wheel with PPG epoxy primer and proceeded with the PC-7. It will come out as perfect as David's wheel if you're willing to take the time.

Peter
 
I used PC-7 same as above but after several years the cracks are starting to show.
 

Attachments

  • IMG_8396.jpg
    IMG_8396.jpg
    65.3 KB · Views: 65
So this wheel has a chip in its center. Im going to drill a few 1/16" holes on it like 1/16" deep. I think i will fill and re-shape the chip with icing glaze. There are no cracks on the front side. The cracks on the back were real small hair line. Last night i filled those cracks with thick CA glue. Today i sanded it smooth with 500, the went away basically.

Maybe then i will just paint it flat black an cover it with a coat of urethane clear and some flattening paste?
 
Sheldon,


There are soft plastic countersunk washers available for that purpose, but I don't use them. I just proceed very carefully, especially with '32 standard moldings where the paint on them is lacquer. With modern clear over new woodgraining, less caution is required.
 
You must log in or register to reply here.
Back
Top