FlatheadTed
Well-known member
Is there a way of pulling the rear hubs with out a commercial puller ,I noticed there's a reases on the early hubs that could be gripped on . who repops ,sells a puller ? Thanks Ted
rear wheel puller
- Thread starter FlatheadTed
- Start date
Sometimes you can loosen up the axle nut just a little and drive it around the block
turning the steering wheel back and forth and it will loosen up. You can also thread a
chunk of round stock to screw on to the axle and pull back on the wheel and hit
the round stock with a big hammer to pop it off. Do both it might work, it has worked for me in a pinch.
Otherwise you need the proper puller.
turning the steering wheel back and forth and it will loosen up. You can also thread a
chunk of round stock to screw on to the axle and pull back on the wheel and hit
the round stock with a big hammer to pop it off. Do both it might work, it has worked for me in a pinch.
Otherwise you need the proper puller.
FlatheadTed
Well-known member
OK thanks
jwaldrich
Senior Member
There is an inexpensive "knock off" puller available from the vendors. Works good. I somehow ended up with 2 of them!
http://www.snydersantiqueauto.com/knock-off-wheel-puller
http://www.snydersantiqueauto.com/knock-off-wheel-puller
