Rear Main Bearing

Re: Rear Main Bearing -- drain Pipe

Is there a supplier that has replacement rear main bearing drain pipes? I have a '34 V8 engine with an unvented block and would like to install a pipe since there isn't one currently in place.

I can buy some pipe and a die from MSC, but it would cost far more than just buying a pipe . . . if I can find one. I've only been able to find pipes for '30-'31 Model A and '39-'42 engines. Given that this is the only flathead I've ever owned, I don't know if either of the above would work.
 
Bob Bidonde said:
My experience running without the tube differs from Vince's because there was no excessive leakage out of the rear main bearing. I won't argue the science of the drain tube, but I have two NOS Ford bearing caps with tubes and no tack welds.
Click to expand...


The question is when were they made?

From various reports, parts known to be made after production are not made like production era parts. They may have been done by contractors and not up to the production line standards.
I have some later Ford NOS rods and they are not +-1 gram the correct weight. I know of people with NOS flywheels that were not balanced and were known later production.
So you need to know more about the parts you have and be careful. Also Ford was known to not waste stuff. So parts that would not be used on the line cause something was off might be sent to the dealers for parts stock.

Anyway, stuff to consider.
 
Re: Rear Main Bearing -- drain Pipe

rjhink said:
Is there a supplier that has replacement rear main bearing drain pipes? I have a '34 V8 engine with an unvented block and would like to install a pipe since there isn't one currently in place.

I can buy some pipe and a die from MSC, but it would cost far more than just buying a pipe . . . if I can find one. I've only been able to find pipes for '30-'31 Model A and '39-'42 engines. Given that this is the only flathead I've ever owned, I don't know if either of the above would work.
Click to expand...


This link may help. http://www.fordbarn.com/forum/showthread.php?t=199701&highlight=rear+main
 
Bill Barlow's babbitting service in Bend, OR may be able to help if you just need to replace the cap. He may have a good cap and can babbitt and bore to your crank size for a reasonable cost. He's at 541-389-2694 or babarlow@bendcable.com.
 
jfreddie said:
Bill Barlow's babbitting service in Bend, OR may be able to help if you just need to replace the cap. He may have a good cap and can babbitt and bore to your crank size for a reasonable cost. He's at 541-389-2694 or babarlow@bendcable.com.
Click to expand...

There was a recent discussion here that Bill Barlow has stopped doing the bearing rebabiting service, a real loss.
 
Re: Rear Main Bearing -- drain Pipe

rjhink said:
Is there a supplier that has replacement rear main bearing drain pipes? I have a '34 V8 engine with an unvented block and would like to install a pipe since there isn't one currently in place.

I can buy some pipe and a die from MSC, but it would cost far more than just buying a pipe . . . if I can find one. I've only been able to find pipes for '30-'31 Model A and '39-'42 engines. Given that this is the only flathead I've ever owned, I don't know if either of the above would work.
Click to expand...

As this a V8 the main thing will be the length of the pipe correct very important give Mac Van Pelt a call he will give the length
 
You must log in or register to reply here.
Back
Top