Rear bumper arm assembly for a 31 Vicky

james heider

james heider

Senior Member
I am in need of a set of rear bumper arms for a 31 Vicky.
I have looked through the parts price list9 Little green book) and many of the suppliers catalogs and I dont see a set for the Vicky.

Are they special? Will town sedan or two door sedan brackets work?
Any help is appreciated.

Jim
 
Vic rear bmuper brackets are only Victoria. All others are different. Their are 21 different rear bumper braces per side.
 
The vicky and A400 have the same arms BUT the up rights are different length the vicky is 4 1/2" and the A400 is 2 1/2" also they are located in a different spot on the arms James I can send you a picture of the A400 ones with measurements they are on my chassis the ones on my vicky are hard to get a picture of.
 
I have a question. I have a Slant Window Town sedan. I also need rear bumper brackets. I plan on having the side mount and no spare on the back. Would I be able to buy the 4DR sedan brackets and add the proper uprights ? What's left on mine measure 4 1/2 from top to center of rivets. I see them in Snyder's Catalog. Does anybody have pics of the correct ones. The ones that were on mine were chopped & welded.
 
MAP said:
I have a question. I have a Slant Window Town sedan. I also need rear bumper brackets. I plan on having the side mount and no spare on the back. Would I be able to buy the 4DR sedan brackets and add the proper uprights ? What's left on mine measure 4 1/2 from top to center of rivets. I see them in Snyder's Catalog. Does anybody have pics of the correct ones. The ones that were on mine were chopped & welded.
Click to expand...

The original brackets on my S/W sedan fit perfectly, and measure a wee bit more than 4-3/4" from the top surface to the center of the rivet. (Call it 4-13/16").

Doug
 
Doug, I'll have to take a closer measurment of that bracket(riser). One was broken off the other was there but not sure if it was correct. I did measure from the bottom below the rivet and I believe that dim. was 5". Is there any site that might show an example of the complete SW bracket ?
 
Happy Thanksgiving All ! Great pics Doug. I wish mine looked like that. Mine are chopped off after the risers and (I don't think you could call it welding) a rear section welded on. Good luck with the car.
 
On one of mine, the topmost portion of the riser (where the bolt holes are) had cracked off, and I had to repair it. This must happen a lot. Now they are all painted and purty-looking and back on the car. But sooner or later I have to shell out the $$$ to get the bumpers themselves re-plated...

Doug
 
You must log in or register to reply here.
Back
Top